Customer Support
Search:     Advanced search

Error 81 After Updating SteerCommand or OnTrac3

Article ID: 2215
Last updated: 18 Apr, 2019
Revision: 2
Views: 256

Content 

After updating your SteerCommand or OnTrac3, there could be instances an Error 81 appearing when trying to autosteer.  This unknown error is appearing because the display cannot interpret what the actual error is.  Most instances are appearing after users are updating because of the week rollover.    

Resolution

Updating the display firmware will remove the error or an actual message will appear.  Display firmware can be found in the Software and Firmware section by clicking here.  If the error is still populating, please contact Technical Support.  


Content last reviewed on: 4/18/19
Reviewed by: LM