Customer Support
Search:     Advanced search

Q: What requirements must be met for coverage logging with the Planter Monitor Module (PMM)?

Article ID: 1085
Last updated: 02 Dec, 2013
Revision: 1
Views: 1532

Question: What is needed for coverage logging with the PMM?

Answer:

  • PMM only with shaft speed sensor: Area on/off will be toggled on from off if shaft speed sensed by the PMM is greater than 0. Area on/off will be toggled off from on if shaft speed sensed by the PMM is equal to 0. 
  • PMM only without shaft speed sensor: Area on/off will need to be manually toggled by the area on/off button in the lower right corner of the screen. 
  • PMM with clutch control: The system will map when clutch sections are on and ground speed is present.
  • PMM with rate control: The system will map when hydraulic drive(s) shaft speed RPM is greater than 0 and ground speed is present. 
  • PMM with clutch and rate control: The system will map when drive shaft speed RPM is greater than 0, ground speed is registering and clutch sections are on.